It happens every summer – honey extraction. After babying the bees, feeding, monitoring, re-queening, splitting, and just plain worrying about them, now is the moment of truth.  How much honey did they deposit in the combs for me to rob from them? I won’t leave you in suspense – I extracted 120-130 pounds from two strong hives.

I opened my third hive and the bees were all gone and the wax moths had starting to infest the wax- very nasty! Once wax moths take over a vacant hive (the bees would throw them out in a populated hive), you might as well throw all the frames away.

Big Event

The biggest event to happen in a beekeeping year is honey harvest. I try to put it off until the end of summer to get the pick of all the nectar that has been collected all spring and summer long to make a mixture of wildflower honey. A multi-day affair that has to be done in the heat of summer, it is the culmination of all my effort (and the bees!) that started last year when I installed my bees. Go to A Bee Nuc or Package to see how to install bees in hives.

My two over-wintered hives and one captured swarm were humming along with our good weather bringing on a consistent supply of nectar. The steady availability of pollen and nectar starting early and continuing throughout the spring and summer almost always ensures a good honey harvest.

It is always an anti-climax when we finally remove and extract – kind of like Christmas – lots of build up and anticipation, and then it is over very quickly and we are mopping up the mess. And mess it is, with sticky honey spilled, and extracted frames with residual honey left to be cleaned up by the bees.

Extracting & Spinning

After removing the bees, by brushing them off the combs (easier said then done), we were ready to spin out the honey with our extractor. Many of my friends ask to help me with this difficult task, but it is such a long slog in hot sweaty weather, where you are more likely than not going to be stung, I strongly discourage them. Plus, they can get in the way!

To remove the wax cappings (the wax that covers and protects the stored honey), a heated knife is used to melt away the wax, and a fork that looks like a hair pick is used to further open up the cells so that the honey can be flung out.

 

Extractor

Think of a large metal trash can with wire shelves inside that spin around and you have an honey extractor.  A motor attached will turn on the merry-go-round inside, flinging the honey deposited in the cells onto the side of the trash can, dripping down to the bottom where it will exit through a gate valve into a mesh sieve straining bee parts and then into a collection bucket.

Fresh wax cappings are very tasty and we dove right in and started snacking.  Grabbing a dollop of warm fresh honey comb that is dripping with honey  is luscious! This year the color of the honey was darker than the usual golden hue we get, probably due to the selection of nectar available when depositing it into the combs.

 Aftermath

Once the honey is all extracted, I take the frames and set them up in front of the hives so the bees can wring every last drop of honey from them. The bees, once they discover the free honey, go crazy and buzz around the yard.  I am sure to avoid having guests over when this happens as it can be quite unnerving if you are afraid of bees.

We set up the sticky extractor and all the tools in front of the hives also so the bees can finish cleaning. The wax cappings are set out along with everything else for the bees to clean, and then I take the wax in to process in preparation for making beeswax soap and candles. Go to Beeswax-Honeybee Gift to see how I process and use beeswax.

Giving the honey a few days to settle, I start bottling the honey when the weather is still warm, over 75 degrees. If honey gets too cold, it won’t flow properly into my jars.