Spinning Honey

Setting up the extractor which looks like a large metal trashcan in my potting shed

Big Event

It happens every August – honey extraction! After babying the bees, feeding, monitoring, re-queening, splitting, and just plain worrying about them, now is the moment of truth.  How much honey did they deposit in the combs for me to rob from them? I won’t leave you in suspense – I extracted 50 pounds from one of my three hives. Two were Nucs and one was a package. Go to A Bee Nuc or Package to see the difference and advantages. The other hives didn’t have enough to extract as the bees need collected honey to survive the winter.

Bee package which includes a queen and 12,000 to 15, 000 bees as a starter
Bee package which includes a queen and 12,000 to 15, 000 bees as a starter

My two nucs and one package were humming along with our wet weather bringing on a consistent supply of nectar. It is always an anti-climax when we finally remove and extract – kind of like Christmas – lots of build up and anticipation, and then it is over very quickly and we are mopping up the mess.

Installing a Nuc involves transferring frames from a working mini hive into a larger hive body home
A Nuc is a miniature working hive

Extracting

After removing the bees, see Robbing the Bees-A Honey of a Day to see how to do this tricky part, we are ready to spin out the honey.

A perfect capped frame of honey
A perfect capped frame of honey

To remove the wax cappings, a heated knife is used to melt away the wax and a fork that looks like a hair pick is used to further open up the cells so that the honey can be flung out.

Using an uncapping fork to remove wax covering
Using an uncapping fork to remove wax covering
A perfectly capped frame of honey

Think of a large metal trash can with wire shelves inside that spin around and you have an honey extractor.   A motor attached will turn on the merry-go-round inside, flinging the honey deposited in the cells onto the side of the trash can, dripping down to the bottom where it will exit through a gate valve into a mesh sieve for bee parts and then into a collection bucket.

The wax cappings are very tasty and we dive right in and start snacking.  Grabbing a dollop of warm fresh honey comb that is dripping with honey  is luscious!

Wax cappings full of honey
Wax cappings full of honey

 Aftermath

After extracting the bees are very active

Once the honey is all extracted, I take the frames and set them up in front of the hives so the bees can wring every last drop of honey from them. The bees, once they discover the free honey, go crazy and buzz around the yard.  I am sure to not have guests over when this happens as it can be quite unnerving if you are afraid of bees!

 

We set up the extractor and all the tools in front of the hives also so the bees can finish cleaning. The wax cappings are set out along with everything else for the bees to clean, and then I take the wax in to process in preparation for making beeswax soap and candles. Go to Beeswax-Honeybee Gift to see how I process and use beeswax.

Weighing my wax harvest

Giving the honey a few days to settle, I start bottling the honey when the weather is still warm, over 75 degrees. If honey gets too cold, it won’t flow properly into my jars.

Bottled honey
Bottled honey

 

 

14 Replies to “Spinning Honey”

Leave a Reply