Spinning Honey

Honey coming out of the extractor into a bucket lined with a mesh paint strainer to remove all bee parts

Big Event

It happens every Fall – honey extraction! After babying the bees, feeding, monitoring, re-queening, splitting, and just plain worrying about them, now is the moment of truth.  How much honey did they deposit in the combs for me to rob from them? I won’t leave you in suspense – I extracted 35 pounds from one of my three hives. Two were Nucs and one was a package. Go to A Bee Nuc or Package to see the difference and advantages.

Bee package which includes a queen and 12,000 to 15, 000 bees as a starter
Bee package which includes a queen and 12,000 to 15, 000 bees as a starter

I started out with 3 hives this season – one Nuc swarmed and the other two did fine, humming along with our wet weather bringing on a constant supply of nectar. It is always an anti-climax when we finally remove and extract – kind of like Christmas – lots of build up and anticipation, and then it is over very quickly and we are mopping up the mess.

Installing a package in the spring
Installing a package in the spring

Extracting

After removing the bees, see Robbing the Bees-A Honey of a Day to see how to do this tricky part, we are ready to spin out the honey.

A perfect capped frame of honey
A perfect capped frame of honey

To remove the wax coverings, a heated knife is used to melt away the wax and a fork that looks like a hair pick is used to further open up the cells so that the honey can be flung out.

Using an uncapping fork to remove wax covering
Using an uncapping fork to remove wax covering

Think of a large metal trash can with wire shelves inside that spin around and you have an honey extractor.   A motor attached will turn on the merry-go-round inside, flinging the honey deposited in the cells onto the side of the trash can, dripping down to the bottom where it will exit through a gate valve into a mesh sieve for bee parts and then into a collection bucket.

The wax cappings are very tasty and we dive right in and start snacking.  Grabbing a dollop of warm fresh honey comb that is dripping with honey  is luscious!

Wax cappings full of honey
Wax cappings full of honey

 Aftermath

Once the honey is all extracted, I take the frames and set them up in front of the hives so the bees can wring every last drop of honey from them. The bees, once they discover the free honey, go crazy and buzz around the yard.  I am sure to not have guests over when this happens as it can be quite unnerving if you are afraid of bees!

We set up the extractor and all the tools in front of the hives also so the bees can finish cleaning. The wax cappings are set out along with everything else for the bees to clean, and then I take the wax in to process in preparation for making beeswax soap and candles. Go to Beeswax-Honeybee Gift to see how I process and use beeswax.

2 lb block of beeswax
2 lb block of beeswax

 Giving the honey a few days to settle, I start bottling the honey when the weather is still warm, over 75 degrees. If honey gets too cold, it won’t flow properly into my jars.

Bottled honey
Bottled honey

 

 

11 Replies to “Spinning Honey”

Leave a Reply